View single post by chrisl
 Posted: 03-06-2018 12:22 pm
PM Quote Reply Full Topic
chrisl



Joined: 09-21-2006
Location: Perth, Australia
Posts: 113
Status: 
Offline
I'd be interested in knowing exactly where you drilled that little lever on the latch assembly..do you have a measurement or template??

Hi Frank

Here's a close up of the mechanism that 'clamps' the boot (trunk) lid down, unbolted so that you can get a better look. You'll see I drilled a hole about 7mm from the rear uppermost corner of the release paddle as shown:

Attachment: JH boot release A Mar 2018.JPG (Downloaded 58 times)