View single post by redracer
 Posted: 01-31-2018 01:35 am
PM Quote Reply Full Topic
redracer

 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 652
Status: 
Offline
 Besides the above mentioned flywheel bolts(I use #2 Permatex and teflon tape on the upper threads), you may want to be sure the oil thrower doesn't have one of its "fingers" between the housing and block. The "5 o'clock" finger is notorious for getting wedged there, and will cause a bad leak.
When replacing the seal housing, be sure to look up from underneath as you put the bolts in. A couple of extra long bolts just to align the the housing may be helpful.