View single post by redracer
 Posted: 08-21-2017 12:27 am
PM Quote Reply Full Topic
redracer

 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 652
Status: 
Offline
 Don: have quite a few used ones; I'll have to bench yest them first but I advise you do that to yours first.
Getting at/to the stablilizer is not all that difficult if you're not huge.
I'm not small but I'm not a "load" so by putting the seat all the way Back and slithering under the dash upside down with a #2 cross point/pozidrive bit, you could undo the stabilizer, but first I'd take a VOM under there and see if in fact you are getting 9V output and not the errored 12V.