 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 02-05-2015 |
| Location: | Saint Augustine, Florida USA |
| Posts: | 169 |
| Status: |
Offline
|
Last edited on 02-03-2017 02:38 am by Bfitz241
| View single post by Bfitz241 | |||||||||||||
| Posted: 02-03-2017 02:36 am |
|
||||||||||||
Bfitz241
|
OK....as an alternative, is the centre of the attaching fitting machined as a hex so as to allow the use of an allen wrench to tighten it? I can't see the oil filter fitting just being screwed in by hand....then again it is British....I can see them using the filter as a nut to hold the whole mess together ...guess I should just pull the filter and get a mirror....Tomorrow's project...thanks for trying Last edited on 02-03-2017 02:38 am by Bfitz241 |
||||||||||||
|
| |||||||||||||