View single post by flatlanderep
 Posted: 09-28-2016 03:21 am
PM Quote Reply Full Topic
flatlanderep



Joined: 06-24-2006
Location: Charlotte, North Carolina USA
Posts: 106
Status: 
Offline
 OK, more temp sensor. I removed the temp sensor and prior owner put a yellow plumbers tape around the threads. I found a post from 2006 where the JH guru, Mark Rosenbaun, posted that need to use Permatex and do not use plumbers tape. So I removed tape, put Permatex on threads and re-installed it. No luck, still did not work but I noticed w that just by turning the key without starting, the temp gauge moved to far right. So I disconnected the green wire and still went to to far right by only turning the key. At this point I don't think a new temp sensor will matter. Any ideas?
Steve