View single post by redracer
 Posted: 07-31-2016 02:15 pm
PM Quote Reply Full Topic
redracer

 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 652
Status: 
Offline
 For ALL the hoods/bonnets I have reinstalled, they have all been the same: namely the front bolt goes as high as possible and the rear bolt as low as possible. To prevent sideways movement, removing each hinge assembly(put a pad on the back corner of the hood for the side you are removing to prevent paint damage) separately and use a small press/or whatever on the 2 large rivets to "tighten" them up. Reinstall and do the other side