 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 07-12-2013 |
| Location: | San Francisco, California USA |
| Posts: | 124 |
| Status: |
Offline
|
Clinton
| View single post by Screenplay | |||||||||||||
| Posted: 04-27-2016 06:04 pm |
|
||||||||||||
Screenplay
|
Is this the 1/4" steel cover plate that bolts to each side of there transmission tunnel? If so, it has always been my understanding that the primary purpose of this plate is for structural rigidity - it connects the unit body floor pans at a weak spot. Perhaps that was just an assumption on my part. Can anybody else chime in? Clinton
|
||||||||||||
|
| |||||||||||||