View single post by Brett Gibson JH5 20497
 Posted: 03-27-2016 03:00 pm
PM Quote Reply Full Topic
Brett Gibson JH5 20497

 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
 Clinton is right on the money but seeing you haven't done this before or seen apart just what you are dealing with it is a bit difficult to visualize. The thing sits on a stud that is screwed into the block, that stud is the pivot point for getting tension. Take the nut off the stud and the thing is supposed to come off and you can put it on the bench and change out the bearings. Won't come off, seems stuck ?? this is a common problem, it is either stuck on the stud or in the front cover, put the correct size wrench on the torsion hex and try working it back and forth so it loosens up, freeing from the stud or cover, still won't come then you will need to try and get behind it and pry it out. If you want photo's send me a PM with your e-mail.

Brett