View single post by Jensen Healey
 Posted: 03-25-2005 03:01 am
PM Quote Reply Full Topic
Jensen Healey



Joined: 03-11-2005
Location: San Anselmo, California USA
Posts: 983
Status: 
Offline
 I used a 16 gage version, that's all my local sheet metal shop can bend. It is screwed to the old bent up original. While I may not be able to jack the car from it without a long block, it does seem better than the lightweight structure the JH uses for a frame.

I also used bar stock to make the seat braces in the interest of rigidity.

Kurt Housh

JH 13148 See me in the WINNER'S CIRCLE at the Dixon CA meet in May! I guess I'll have to stop trading votes for beer before I make a mockery of the entire event!

http://www.ubscc.org/dixon.htm