View single post by Randallclary@icloud.com
 Posted: 01-04-2016 05:26 am
PM Quote Reply Full Topic
Randallclary@icloud.com

 

Joined: 10-04-2013
Location: Riverside, California USA
Posts: 111
Status: 
Offline
 I chime in and say the same thing. I used the std gaskets provided by Delta Motor Sports and did in initially the following way:

1. Put black Permatex on both sides of the gasket material and then place the gasket on the cam cover.
2. Put each hex head bolt and sealoc washer and gently tighten each bolt in an alternating pattern and gradually tighten each to the recommended torque setting making sure that the gasket is not squeezed out by pushing any portion of the gasket back into the seal area..
3. Wait one day and retorque each bolt making sure that the gasket is not squeezed out..

Well mine still leaked. Any method that works 100%? I'm really in need of a fix to cure this leak.

I just completed my stroker crank rebuild and am so happy with the result of HP and especially torque. Just need to fine tune. What a ride!!!