 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 07-12-2013 |
| Location: | San Francisco, California USA |
| Posts: | 124 |
| Status: |
Offline
|
I hope this makes sense - words are escaping me this morning.
Clinton
Last edited on 12-11-2015 04:51 pm by Screenplay
| View single post by Screenplay | |||||||||||||
| Posted: 12-11-2015 04:29 pm |
|
||||||||||||
Screenplay
|
I'm assuming that you are trying to slide the clip into the groove. It doesn't necessarily go back on the same way it came off. Instead, square the clip with the part of the cylinder that protrudes through the backing plate and press it flat against the backing plate with both thumbs until the clip snaps into the groove. I hope this makes sense - words are escaping me this morning. Clinton Last edited on 12-11-2015 04:51 pm by Screenplay |
||||||||||||
|
| |||||||||||||