 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 09-10-2012 |
| Location: | Little Chute, Wisconsin USA |
| Posts: | 435 |
| Status: |
Offline
|
| View single post by answerman | |||||||||||||
| Posted: 10-02-2015 05:13 pm |
|
||||||||||||
answerman
|
Thanks for the info, Kurt. At this point what I'm going to do is bring the head and block over to the machine shop at the end of the month and wait for his opinion on the condition of the lower end. If I do end up replacing the pistons, then it sounds like the HC pistons may be the way to go.
|
||||||||||||
|
| |||||||||||||