 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-21-2005 |
| Location: | Waitomo Caves, Otorohanga, New Zealand |
| Posts: | 40 |
| Status: |
Offline
|
The input shaft housing on the Jensen has the shaft that the clutch release bearing slides on, the Hunter gearbox ( on LHS of photo ) does not have this shaft.
The other difference that I wish I found out about earlier was that the tip of the Input shaft that goes into the roller bearing in the fly wheel is approx 15 mm diameter for the Jensen but is 16 mm diameter on the Hunter. I will get the machine shop to take the replacement from the hunter gearbox to fit the flywheel.
In photo you can see the similarities on the bell housings also.
Attachment: input shafts1.JPG (Downloaded 28 times)