 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 07-10-2012 |
| Location: | Whitehills , United Kingdom |
| Posts: | 168 |
| Status: |
Offline
|
No idea who you got the exhaust from but it's not in the standard configuration which was two 1.75" pipes over the axle. Mines not standard either and was fabricated from 2.5" 304 stainless. It's hard to explain but from the bracket under the seat it needs to go up at an angle towards the outside of the car, then straight back over the axle, then down towards the car centreline, then straight back to the silencer. I used Jetex short elbows which are available in mild or stainless steel from 1.75 to 3.0" - if you can't find them locally try Merlin Motorsport.
From the photos yours looks like the front need to be shortened by about 20mm and the rear section over the axle re fabricated.
Best of luck
Gordon