View single post by Jim Ketcham
 Posted: 03-13-2015 07:51 pm
PM Quote Reply Full Topic
Jim Ketcham

 

Joined: 03-13-2005
Location: Salt Point, New York USA
Posts: 208
Status: 
Offline
 The two bolts that hold the steering rack pass thru the front cross member from front to back. The nuts (9/16" IIR) can be accessed from under the car (easiest with car on a lift) on the rear side of the front cross member. I use a socket with a long extension. The bolt heads are circular with a flat side that is supposed to keep the bolt from spinning.
When changing the steering shaft I just loosen the nuts to give enough freeplay of the rack to slip the shaft over the spline.

Good luck,
Jim