View single post by Bfitz241
 Posted: 02-27-2015 03:24 am
PM Quote Reply Full Topic
Bfitz241



Joined: 02-05-2015
Location: Saint Augustine, Florida USA
Posts: 169
Status: 
Offline
 In the process of installing my distributor I stuck my finger in the hole and felt the spring in the pump was still there. Does that need to center perfectly on the distributor drive? in other words, should I remove the spring and place it on the center drive and install the whole assembly?
Second question, I found a small spring, about 3/4" long, maybe 3/16 diameter laying on the engine under the distributor...is this a crucial part or extra junk on my engine? It looks like a large pen spring....Thanks for any input.