 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 04-10-2009 |
| Location: | Hubbard, Ohio USA |
| Posts: | 104 |
| Status: |
Offline
|
| View single post by StevenD57 | |||||||||||||
| Posted: 02-21-2015 08:49 pm |
|
||||||||||||
StevenD57
|
What is he doing about the clutch actuation? The Excel was a hydraulic clutch verses the mechanical cable type on the JH. I used an Excel bellhousing and I had to enlarge the hole for the arm to stick out and locate a pivot pin over on the other side of the bellhousing (on the inside).
|
||||||||||||
|
| |||||||||||||