 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 12-13-2007 |
| Location: | |
| Posts: | 42 |
| Status: |
Offline
|
Attachment: Distrib.JPG (Downloaded 244 times)
| View single post by mcguan.2 | |||||||||||||
| Posted: 02-14-2015 08:52 pm |
|
||||||||||||
mcguan.2
|
So upon removing the distributor cap, I see it is petronix, and the rotor inside just freely rotates, so I set about trying to re-seat the distributor. Unfortunately, I was only able to wiggle and twist it in as far as the picture shows, with about a 1/4" gap at the rear end. Is this as far as it should go? No matter how hard I try, I can't cajole it past that point, and the rotor is still freely spinning. Attachment: Distrib.JPG (Downloaded 244 times)
|
||||||||||||
|
| |||||||||||||