View single post by redracer
 Posted: 02-04-2015 07:18 pm
PM Quote Reply Full Topic
redracer

 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 652
Status: 
Offline
 Putting each of the bearings flush with the surface of the outer casing is fine(there will be a little space in the center) but don't worry about them pressing aaginst each other. I usually put a very small amount of Loctite(242 is fine) on the surface of the outer shell where the outside part of the bearings mate, just to be sure