View single post by CoryB
 Posted: 01-31-2015 06:53 pm
PM Quote Reply Full Topic
CoryB

 

Joined: 01-25-2013
Location: Stanwood, Washington USA
Posts: 10
Status: 
Offline
 After I replaced the timing belt and the tensioner bearings, I discovered the timing belt runs towards the back side of the cam pulleys. This is new as the old belt ran smack in the middle of the pulleys. I know there is a flange built in to the crankshaft timing belt pulley, so it can't go off the backside. I have put straight edges across all the pulleys and they line up perfect, except the crankshaft pulley is farther back by about 3/16 inch. But, my real question is: When you press the new tensioner bearings in to the outer shell, how do you know where to stop? Is the face of the tensioner shell suppose to be flush with the face of the bearings? That "seems" to put the outer shell in the middle of the belt.

Anyone know? Thanks.