 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 07-12-2013 |
| Location: | San Francisco, California USA |
| Posts: | 124 |
| Status: |
Offline
|
Flat side UP against the rubber seat that sits against the subframe. The lower control arm is shaped to accept the bottom of the spring and will fit only one way. Upon reassembly, before the bottom side of the spring and the lower arm make contact, rotate the spring until it fits "snugly" in that lower control arm. You'll see the contour and how it fits.
It sounds as if you're making some real progress. If only I could get mine to move as quickly! Best of luck.
Clinton
Last edited on 01-17-2015 10:36 pm by Screenplay