View single post by StevenD57
 Posted: 12-21-2014 05:54 am
PM Quote Reply Full Topic
StevenD57



Joined: 04-10-2009
Location: Hubbard, Ohio USA
Posts: 104
Status: 
Offline
 I am in Ohio now but I have not been able to locate a good CNC capable machine shop yet that seems interested in doing these small job lot type of things.

The last machine shop I had in Phoenix had time control issues (they would promise to have something ready in a week or two and then still not have anything done three or four weeks later). When I finally confronted the owner about this after having the project drag on for WAY too long he threw the project back in my face and refused to share any of the intellectual property I had developed.

I have two semi-finished bellhousings. One for the W58 and another for the T9. The T9 conversion bellhousing is somewhat simpler than the W58 due to the simple bolt pattern for the T9.

Last edited on 12-21-2014 06:03 am by StevenD57