View single post by Gary Martin JH 15371
 Posted: 09-13-2014 05:34 pm
PM Quote Reply Full Topic
Gary Martin JH 15371

 

Joined: 03-12-2005
Location: Portland, OR
Posts: 98
Status: 
Offline
 Remove the two screws at the top of the cluster. In the center of the cluster on the back side, you will see a metal rod, about a quarter inch in diameter and a few inches long. That rod holds the cluster to the dash. If it was like my car the rod was quite rusty. Clean the rod up and oil it. Then push the rod from the back side towards the steering wheel. It is a press fit, but should come loose.