View single post by srq2002
 Posted: 09-10-2014 01:05 am
PM Quote Reply Full Topic
srq2002

 

Joined: 07-14-2014
Location:  
Posts: 24
Status: 
Offline
 This undoubtedly is an old question. but how does one get the distributor drive shaft to engage?

I can get the distributor to "snap" back into the oil pump housing, but no matter how I turn the distributor body or the rotor I have not been able to get the drive shaft to engage (turn the dizzy pulley and there is no motion at the rotor).
 
What step(s) is/are needed for success?

Thanks in advance!