 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-12-2005 |
| Location: | Dallas, Texas USA |
| Posts: | 74 |
| Status: |
Offline
|
| View single post by mdutch | |||||||||||||
| Posted: 08-26-2014 05:59 pm |
|
||||||||||||
mdutch
|
Having a devil of a time getting the distributor seated properly. My understanding is, I have to move the rotor to engage the bottom of the shaft and its offset key into the distro drive shaft. Is that correct? I would think if the rotor is still turning freely then the shaft is not engaged. It doesn't look like the body of the distro is fully engaged with the clamp and the rotor still spins. Am I correct?
|
||||||||||||
|
| |||||||||||||