View single post by Art DeKneef
 Posted: 08-07-2014 03:22 am
PM Quote Reply Full Topic
Art DeKneef

 

Joined: 03-12-2005
Location: Mesa, Arizona USA
Posts: 338
Status: 
Offline
 I suppose it could be possible if one side was raised higher than the other when you tighten the nuts and bolts. If one side was higher or lower when tightened I think it would take some time for it to level out. If it could.

When I had my car back together before I torqued everything down, I had all 4 tires sitting on car ramps. This came me clearance to slide under the car while laying on the crawler and put all the weight on the tires. Then it was just a matter torqueing the nuts and bolts to the proper spec. Was pretty easy to do that way. Plus you can check out the underside of the car and look for things that might need to be repaired.