 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 10-31-2013 |
| Location: | Denmark |
| Posts: | 67 |
| Status: |
Offline
|
I have had problems with my servo unit lately and it has turned out they my old vacuum hose was blocked, needs to be replaced.
I goes from the inlet manifold to a small plastic T. From the T there is a connection to the servo unit and a small hose going to the small valve mounted inside the car next to the heater.
In the small hose i found a non return valve . It was mounted correctly meaning that the engine could draw vacuum through it.
Any Idea on why it is mounted inside this hose?
What kind of hose are you using as Vaccum Hose? Connections on both manifold and servo unit is 10 mm.
BR
kim
Last edited on 08-03-2014 03:36 pm by Barthol