 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 09-21-2006 |
| Location: | Perth, Australia |
| Posts: | 113 |
| Status: |
Offline
|
Am finally getting my Mk1 JH back on the road after a layoff. So far so good.
I am trying to track down an adjusting wrench for the timing belt tensioner for the Mk 1 motor. It's a bit of a specialised tool, a 38mm flat spanner that has a 90 degree angle at its head in order to get behind the bearings.
In hindsight should have converted to the Mk2 setup, but hindsight is a perfect science...
If you have one lying around I'd be happy to buy it!