 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 07-10-2012 |
| Location: | Whitehills , United Kingdom |
| Posts: | 168 |
| Status: |
Offline
|
Got the studs from HiSpec listed on the invoice as 'wheel stud 7/16" +13mm.
You may also need the following which I got from Merlin motorsport SKT-M8-25 Socket cap screws and K-Nut-M8 for the half shaft retainer. You will also need a 3 way brake union as you will not be using the double fitting on the wheel cylinder. I made brackets out of 62mm exhaust clamps to mount the hard pipe/flexi away from the spring base and used a short flexi to the rear calipers - hard piped from the 3 way union.
Gordon