View single post by answerman
 Posted: 06-02-2014 05:23 am
Full Topic
answerman

 

Joined: 09-10-2012
Location: Little Chute, Wisconsin USA
Posts: 435
Status: 
Offline
 I used a #3 Phillips which seemed to work ok to get them apart, but then I went across the street to the hardware store and got socket head Allen screws to replace. Much easier to torque.

As far as adjusting, what I did was to get all the screws in loosely and then put a hydraulic floor jack with a towel over it under the part of the door I wanted to lift.