 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 04-22-2010 |
| Location: | Winchester, United Kingdom |
| Posts: | 33 |
| Status: |
Offline
|
I had mine replaced a few years ago and the installer did not use any rubber seal's, he just laid a thick bead of caulking material, (from a specialized gun) about 3/4" wide and about 1/4" to 3/8" thick, in the frame after he cleaned it and prepped it with a solvent, prepped the edge of the glass all the way around, laid it down on that, applied another layer on the glass, and put the SS. finisher over that, cleaned it up, and its been good ever since, said it was an industry standard application.
Good luck. Brett.
That's how mine was done too.