 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 06-11-2009 |
| Location: | |
| Posts: | 5 |
| Status: |
Offline
|
Also is there a separate thread on using miata mx5 tie rod ends on a JH stealing arm? To correct bump steer on a lowered JH?
| View single post by jamescheesewright | |||||||||||||
| Posted: 05-20-2014 08:51 am |
|
||||||||||||
jamescheesewright
|
Hi people it's been a while since I've been on this forum but I'm back working on my JH again. I'm currently focused on the brakes and in particular the front hubs. I'm going to be running an escort mark two rear axle in the healey so was wondering has anybody ever swapped to ford front hubs off say a Capri 2.8i or a mk2 escort. As this way I would be able to harmonise my wheel bolt pcd to ford 108. At the same time it would allow the vented disc bolt up from a Capri 2.8i. If anyone has the wheel bearing data for the front spindles that would be good as I can then compare it with bearings used also by ford. Also is there a separate thread on using miata mx5 tie rod ends on a JH stealing arm? To correct bump steer on a lowered JH?
|
||||||||||||
|
| |||||||||||||