 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 10-31-2013 |
| Location: | Denmark |
| Posts: | 67 |
| Status: |
Offline
|
I noticed that my Cam Shaft wheels looks like they have been worn down.
Unfortunately I did not notice wheter they looked like this when I changed my cam belt.
Is this normal wear or normal design.
My Cambelt is still tight ( If I twist it right over the termostat housing I can twist it 45 deg) Is this ok for tightness ? It runs without any noise .
Any suggestions on what I should do?
Best regards
Kim
Attachment: cam wheel wear.jpg (Downloaded 424 times)