View single post by Ricardo
 Posted: 12-07-2013 02:51 am
PM Quote Reply Full Topic
Ricardo



Joined: 03-13-2005
Location: Miami, Florida USA
Posts: 19
Status: 
Offline
 the floor pans where made out of aluminum a while back by the PO and riveted to the rails, but the rails are rusting, not just surface rust and ....How do you cut just one section and weld another one in?  Isn't better and simpler to install a new, slightly oversize channel or "u" shaped piece on top of the original one?  I mean, I REALLY DON'T KNOW that is why I'm asking for help from you guys that have done everything to the JH, I wish I knew what you guys have forgotten about the topic.
   Hope to hear from you soon.
   Ricardo