View single post by Ricardo
 Posted: 11-16-2013 02:47 am
PM Quote Reply Full Topic
Ricardo



Joined: 03-13-2005
Location: Miami, Florida USA
Posts: 19
Status: 
Offline
 I just got the CR pistons from the store as I'm doing the 2.2 upgrade on my engine.  My question is:
   1-  What would the clearance be between piston and cylinder wall after it's bored and honed, in other words, the pistons are 3.7775" bore size and according to the enclosed paper the cylinder bore clearance should be  0.0025"; isn't that too close a tolerance? To those of you that have done this successfully ...What was the final CYLINDER bore diameter in your engine?