View single post by Jensen Healey
 Posted: 10-24-2013 04:21 am
PM Quote Reply Full Topic
Jensen Healey



Joined: 03-11-2005
Location: San Anselmo, California USA
Posts: 983
Status: 
Offline
 It is interesting that removing the washer didn't allow the switch to operate. How does the ball contact point on the switch look?
Maybe you could use a piece of wire or a bolt to measure the switch seat to nub distance.
Then compare with the male end of the switch body to make sure it's being engaged.
It may be slop in the shifter isn't moving the nub into position.