 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-12-2005 |
| Location: | Kingman, Arizona USA |
| Posts: | 532 |
| Status: |
Offline
|
The front muffler installs directly to the rear of the Y pipe, with its bent section horizontal and to the rear, allowing the intermediate pipe to loop over the rear axle instead of the differential. The front muffler connects to the straight end of the intermediate pipe, which in turn loops over the rear axle with its curved part facing to the rear. These must be oriented so that there are no interference problems -- it will be tight, with 1/4" clearance or less in some cases. The rear silencer then connects to the intermediate pipe so that its chrome tips face rearward with the rearmost edge of the tips to the top.
Attached is a composite photo showing (1) the orientation for the front muffler, and (2) the junction between the rear of the intermediate pipe and the rear silencer. This may clarify things a bit.
Attachment: exh composite.jpg (Downloaded 136 times)
Last edited on 08-06-2005 03:22 pm by Mark Rosenbaum