View single post by Jim Picot
 Posted: 09-28-2013 09:20 am
PM Quote Reply Full Topic
Jim Picot

 

Joined: 07-09-2012
Location: Melbourne, Australia
Posts: 39
Status: 
Offline
 After removing the bush housings from the axle-end of the lower rear suspension arms (see "Fitting rear Superpro bushes"), I've discovered the steel pressings beneath have corroded. One is not too bad, a hole about the size of a five cent piece, but the other has lost nearly half its metal. The latter is certainly not serviceable, any integral strength it had came off with the bush housing.

The olds ones *may* be repairable, but it would require some clever weld surgery, as the top of the arm would need to be cut and peeled back to provide access for a backing piece to be welded in, then returned and welded in again. Replacements would be much simpler.

So, I need two new lower suspension arms for the rear. I assume new ones aren't available, does anyone have some good-condition old ones they can part with, or know where I might get them?