View single post by Jim Picot
 Posted: 09-25-2013 12:13 pm
PM Quote Reply Full Topic
Jim Picot

 

Joined: 07-09-2012
Location: Melbourne, Australia
Posts: 39
Status: 
Offline
 Post Script - Job done.

No problem drilling out the bush with a 1/2" drill - quick and easy.

Then I used with a 20 mm dia x 250 mm long bar under the bush to support it while I pressed down on the bush from above with a ball-pein hammer in the 20T press. No good - the crown of the hammer face made it impossible to keep it vertically aligned. A socket fitted over the hammer didn't help.

So I ended up holding it by hand and wacking the hammer face with another hammer. Success! It wasn't as pretty as it might have been, but it's tight and secure.