View single post by atgparker
 Posted: 07-16-2013 04:43 am
PM Quote Reply Full Topic
atgparker



Joined: 06-23-2013
Location: Mission Viejo, California USA
Posts: 90
Status: 
Offline
 No, the tail shaft housing will slip right off the out put shaft were there is a nice large plastic gear which drives the speedo cable housings gear and shaft which is screwed to the housing. 

As long as that small housing which the cable attaches to is not frozen up it will spin and allow the plastic gear to move the shaft as the tail shaft housing is pulled away from the center cast iron section of the transmission.