 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 06-23-2013 |
| Location: | Mission Viejo, California USA |
| Posts: | 90 |
| Status: |
Offline
|
Attachment: WP_000468.jpg (Downloaded 357 times)
Last edited on 09-09-2016 01:54 am by atgparker
| View single post by atgparker | |||||||||||||
| Posted: 07-15-2013 09:27 pm |
|
||||||||||||
atgparker
|
I picked up some STP oil treatment with the ZDDP additive in it and was thinking I might soak the rope seal halves in this stuff like you insist? How about not setting the rope seal joints in line with the bearing cap and block joint line? Sort of offsetting the rotation of the seal with relation to the block if you get my drift? That is after I trim each half to be 1/16 longer than the length required for it to be flush in the block and/or bearing cap. Attachment: WP_000468.jpg (Downloaded 357 times) Last edited on 09-09-2016 01:54 am by atgparker |
||||||||||||
|
| |||||||||||||