| View single post by Brett Gibson JH5 20497 | |||||||||||||
| Posted: 06-13-2013 06:27 pm |
|
||||||||||||
Brett Gibson JH5 20497
|
If your looking to pull the rockers the way I would go about it would be, cut the floors out flush to the tunnel and inner rocker sill, seeing you already have the fenders off and doors, cut the rockers off with the inner sill attached, but cut them just above the small weld lip that you can see in the door opening, gets a bit funky at the ends but not much of anything in that area worth saving. Keep in mind what your cutting off gives the car structual strenght, so you will need to compensate, hate to see it break in two and fall on you. I'm talking using a saw-z-all, torch's are messy and could heat warp things. Brett
|
||||||||||||
|
| |||||||||||||
