View single post by roland11a
 Posted: 06-09-2013 09:52 am
PM Quote Reply Full Topic
roland11a

 

Joined: 12-11-2012
Location: Stone. Staffordshire, United Kingdom
Posts: 80
Status: 
Offline
 The rear wing/Fender is also attached with Pop rivets to the B piller and the rear number plate panel. These might be hiding under a skim of filler. Strange though my wings had no weld holding them on so these might have been replaced at some time.

Floor pans need to have the spot welds drilled out but be aware the seat support rails need to be removed first.

If your scrapping the rest as you say cut around the bits you don't want. I find a 1mm disc cutter in an angle grinder is the way to go.

What is a rocker panel in American speak??