View single post by George
 Posted: 08-02-2005 12:59 pm
PM Quote Reply Full Topic
George

 

Joined: 04-05-2005
Location: Boyds, Maryland USA
Posts: 88
Status: 
Offline
Thanks to all for the great help. I put the Pertronix into my old distributor and tried it out - and surprisingly, the timing was close enough to adjust it with the slot in the welded on clamp. So that’s what I did for now. As I am still not happy with set up, I will go ahead and replace it with the one Kurt is sending after I rebuild it. A good small winter project.

Mark - it wasn’t til after I put the old one back in that I remembered to look for the vacuum capsule numbers and now I can’t read them. I’ll send them to you when I take it off to swap it out. Sorry about that. You must have quite a library of JH part pictures!

Now on to the Flamethrower coil.

Thanks again - George