View single post by answerman
 Posted: 09-14-2012 05:15 pm
PM Quote Reply Full Topic
answerman

 

Joined: 09-10-2012
Location: Little Chute, Wisconsin USA
Posts: 435
Status: 
Offline
 Small victories... did some more wire tracing last night and found that the reason the temp gauge wasn't working was because the wire that was supposed to be connected to the sensor was lying down under the carbs. Popped it back on the spade and it works fine. Wish they were all this easy.

Still no tach though. It doesn't move at all. Am I correct in assuming that if the white/slate wire from the tach to the ballast resistor isn't connected, the car won't run? I could just disconnect it and try, I guess, but since I'm here...