View single post by George
 Posted: 06-12-2012 02:16 pm
PM Quote Reply Full Topic
George

 

Joined: 04-05-2005
Location: Boyds, Maryland USA
Posts: 88
Status: 
Offline
 Hi Frank.  I'll try to take a pic and send it.  It was pretty straight forward.  I cut a piece of metal about 8" by 36" and then mounted it under the front valence with the bolts holding on the oil cooler and the side supports for the valence.

I sprayed it with undercoating.  Looks good although I was so concerned about placement front to back, I got it off center side to side(!).  oh well.