View single post by StevenD57
 Posted: 03-31-2012 11:19 pm
PM Quote Reply Full Topic
StevenD57



Joined: 04-10-2009
Location: Hubbard, Ohio USA
Posts: 104
Status: 
Offline
 I have a 16 page article I wrote that I have been E-mailing out for free.

If you PM me with an E-mail address where you can receive a 4Mb - 5Mb pdf file I will send it to you.

What I am selling is a set of parts for a simple bolt-on VR sensor & toothed wheel with near perfect alignment for a single groove crank pulley as used on the 1974 and up Jensen-Healey motor (I.E. without AC)).

I am working on designing a similar kit for the multi-groove crank pulleys on cars with AC. These are a bit more complex and I will probably require some detail photos of your motor before selling on to you so I can make sure it will fit properly.
--
Steve

Last edited on 03-31-2012 11:40 pm by StevenD57