 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 04-05-2006 |
| Location: | |
| Posts: | 35 |
| Status: |
Offline
|
Attachment: auxpulley.jpg (Downloaded 62 times)
| View single post by Bob 13902 | |||||||||||||
| Posted: 01-06-2012 09:18 pm |
|
||||||||||||
Bob 13902
|
Problem solved. The solution was simple once I grabbed a beer and stared at it one last time. I've attached a photo as my setup is not the same as what is shown in the Delta schematic...I have a beveled head bolt going into the large washer (which I did not initially recognize as a washer that I could crank on) rather than a standard hex bolt. I put a pipe wrench on the washer and with some added persuasion (sledge), it loosened right up. Attachment: auxpulley.jpg (Downloaded 62 times)
|
||||||||||||
|
| |||||||||||||