View single post by pbahr
 Posted: 10-20-2011 04:13 pm
PM Quote Reply Full Topic
pbahr



Joined: 04-15-2005
Location: Phoenixville, Pennsylvania USA
Posts: 202
Status: 
Offline
 OK, got it. With that part bad, the rear of the Bracket can move around.

It actually should not move too much unless the bearings on the front, where the Bracket mounts to the Tranny, are really bad. I've found that the Shaft-pivot wears the hole in the aluminum Bracket and that allows the entire Bracket to move around. Also, if you have a later car, there is a rubber bushing in the Support-Shaft pivot that can destroy itself and give similiar problems.

YELODOG