 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 04-05-2005 |
| Location: | Boyds, Maryland USA |
| Posts: | 88 |
| Status: |
Offline
|
George
| View single post by George | |||||||||||||
| Posted: 07-18-2005 07:33 pm |
|
||||||||||||
George
|
I compared a later model MGB one directly with the one from my JH, and the only differences were: 1) as mentioned, the shaft is a little shorter; 2) two pins on the connector need to be switched, but the wire colors are the same, so that's an easy task; and 3) the white plastic collar that operates the turn signal cancellation is a little taller on the MGB switch. Not sure if this makes a difference or not, but I was planning on cutting it down, before I found a new old stock JH switch. Looks like it would be a fairly straight forward job, however. (hope this reply isn't too late to be of any help) George
|
||||||||||||
|
| |||||||||||||